 |
| Crown Molding, Installing |
| This DIY Basic, brought to you by The Home Depot, will provide tips on installing crown molding. |
|
advertisement
|
Crown molding will enhance the look of any room and it can be installed in a weekend.
- Getting the proper tools, like a coping saw and high quality molding products are keys to success.
- The first piece of molding can be nailed into the studs of a wall opposite a door and left square on both ends.
- Pre-drilling holes for the nails will keep you from splitting the wood.
- Cutting along the profile of the molding with a coping saw (figure A) will allow you to create a joint for inside corners.
- The joint can then be dry-fitted (figure B) and adjusted if needed before it’s installed.
- Two simple cuts with a miter saw (figure C) is all you’ll need for exterior corners (figure D).
- The last wall will require both ends of the molding to be coped before you can slip it into place.
- Once the nails are set and the holes are patched and painted, you’ll have professional looking results (figure E).
Web Extras
- The first piece of molding requires no mitering or coping and therefore will look the best. This should be placed along the wall opposite the main entry door because it will be the room’s most noticeable wall.
- Set the coping saw to a cut at a 45-degree angle. Some adjustments may need to be made with a file or sandpaper because not all corners are plumb.
- Paint or stain the molding before installing it. It will save time and yield better looking results.
- When joining boards along longer walls, miter cut each board at a 45-degree angle, don’t butt two square ends together.
RESOURCES :
The Home Depot
Website: www.HomeDepot.com
| 
)
)
)
)
)
WINDOWS MEDIA VIDEO
